TiLite TR Rigid Titanium Wheelchair

Anodized Colors

Seat Width (A):

Measure from outside of seat tube at back post to the outside of the opposite seat tube at back post.

Front Seat Width:

Measure from inside of front frame tube to inside of opposite front frame tube. (Required with V-Front End V. Not Available with Standard Front End I.)

Seat Depth (B):

Measure from front of back post to the front edge of seat sling. Front edge of seat sling will be at the beginning of the bend at front of chair frame, unless Frog Legs or a 90º Front Angle is ordered, in which case front edge of seat sling begins approximately 1” behind the bend.

Ergonomic Seat (U):

Measure from front of back post to beginning of upward bend of seat tube.

Front Seat Height (C):

Measure from floor to top of seat tube at the beginning of the bend.

Rear Seat Height (D):

Measure from the floor to top of seat tube at the back post.

Front Frame Angle (L):

Front Frame Angle (L) Measure from frame front to floor.

TFA2 – Overall Frame Length (M) Measure from front of backrest to Front Edge of Footrest.

Seat to Footrest (E):

Measure from front edge of seat sling to top rear of footrest. Measurement must be at least 2” shorter than Front Seat Height (C)

Front End Type/Footrest Width:

Seat Back Height (F):

Measure from top of back post to top of seat tube at rear of frame.

Seat Back Height (F):

Measure from top of back post to top of seat tube at rear of frame.

Rigidizer Bars:

TSB12 – 4” Deep Backrest Rigidizer Bar (Available with Aluminum backrest option. Not available with a Non-Folding, Fixed Height Titanium Seat Back Type.4” Deep Rigidizer Bar is NOT a rounded style rigidizer bar.) NCO

TSB13 – Custom Height Backrest Rigidizer Bar (The Standard Rigidizer Bar height is 5” above the Seat Sling for a short, 6” for a medium and 10” for a tall. Custom Height Rigidizer Bar must be at least 4-1/2” above Seat Sling. Maximum Height is 3” less than Lowest Seat Back Height without push handles.) $165 Set at:___________(Use 1/4” increments)

Seat Back Angle (G):

Measure angle from front of back post to floor. 90° will be perpendicular to the floor. To approximate the angle from the back post to the seat, subtract 2 degrees from measurement (G) for every .5″ of dump.

Center of Gravity (H):

Measure from front of back post at the seat tube to the center of the rear axle. If no center of gravity is selected, chair will ship with the center of gravity in the rearward-most position.

Rear Wheel Spacing (J):

Measure from outside of seat back post to inside of rear tire. .5” Rear Wheel Spacing not available with 0° or 2° Camber (K)

Camber (K):

TRW17 – X-Core Mag (Not available with Heavy Duty Frame, Short Tabs, Quad Release Axles, Spoke Guards or Omit Handrims Option. Requires Aluminum Sliver Anodized Handrims.)
❑ 20”(451)
❑ 22”(501)
❑ 24”(540)

TRW16 – Spinergy Carbon Blade (Not available with Heavy Duty Frame, Natural-Fit or Natural-Fit LT with Standard Grip or Super Grip.)
❑ 24”(540)
❑ 25”(559) (Requires 15” minimum Seat Depth B.)